Author Topic: Bug: Cannot post in forum  (Read 302 times)

Offline Linkin_J_Knex

  • Sr. Member
  • *
  • Posts: 354
  • Karma: +3/-0
  • Hello! Please visit my Instructables account!
    • View Profile
Bug: Cannot post in forum
« on: September 19, 2020, 11:45:32 am »
Tried uploading photos of my K'nex 3D printer project however the "post" button returns me to a blank "start a new topic".
Linkin_J_Knex - Weapon of mass creation.

Offline Sorunome

  • Administrator
  • Sr. Member
  • ***
  • Posts: 371
  • Karma: +6/-0
  • Keep calm and fox on
    • View Profile
    • My Homepage
Re: Bug: Cannot post in forum
« Reply #1 on: September 19, 2020, 11:47:02 am »
How large are the photos? They might be too large
This is a signature.

Offline Linkin_J_Knex

  • Sr. Member
  • *
  • Posts: 354
  • Karma: +3/-0
  • Hello! Please visit my Instructables account!
    • View Profile
Re: Bug: Cannot post in forum
« Reply #2 on: September 19, 2020, 11:47:57 am »
May be that I'm uploading too many at once. Going to upload them a few at a time
Linkin_J_Knex - Weapon of mass creation.

Offline Callistemon

  • Advanced Newcomer
  • *
  • Posts: 23
  • Karma: +0/-0
  • Brushless motors on base isolation springs
    • View Profile
Re: Bug: Cannot post in forum
« Reply #3 on: September 21, 2020, 04:52:24 am »
Same thing happened when I tried publishing a completed build. It had an error, even though the size of the images was below 65536 kilobytes, and it is stuck as unfinished (orange in the list), and cannot even be deleted. Another time when uploading images to a poll, there were no images afterwards, even though they were uploaded and were less than 64 megabytes.

Offline Sorunome

  • Administrator
  • Sr. Member
  • ***
  • Posts: 371
  • Karma: +6/-0
  • Keep calm and fox on
    • View Profile
    • My Homepage
Re: Bug: Cannot post in forum
« Reply #4 on: October 11, 2020, 05:22:04 pm »
Try keeping them below 50M

not sure what the forum is configured for, but that is the limit on the proxy. time to check the forum config
This is a signature.