Knex Flux

Knex Flux => Site Feedback and Questions => Topic started by: Linkin_J_Knex on September 19, 2020, 11:45:32 am

Title: Bug: Cannot post in forum
Post by: Linkin_J_Knex on September 19, 2020, 11:45:32 am
Tried uploading photos of my K'nex 3D printer project however the "post" button returns me to a blank "start a new topic".
Title: Re: Bug: Cannot post in forum
Post by: Sorunome on September 19, 2020, 11:47:02 am
How large are the photos? They might be too large
Title: Re: Bug: Cannot post in forum
Post by: Linkin_J_Knex on September 19, 2020, 11:47:57 am
May be that I'm uploading too many at once. Going to upload them a few at a time
Title: Re: Bug: Cannot post in forum
Post by: Callistemon on September 21, 2020, 04:52:24 am
Same thing happened when I tried publishing a completed build. It had an error, even though the size of the images was below 65536 kilobytes, and it is stuck as unfinished (orange in the list), and cannot even be deleted. Another time when uploading images to a poll, there were no images afterwards, even though they were uploaded and were less than 64 megabytes.
Title: Re: Bug: Cannot post in forum
Post by: Sorunome on October 11, 2020, 05:22:04 pm
Try keeping them below 50M

not sure what the forum is configured for, but that is the limit on the proxy. time to check the forum config