Knex Parallel Arm Lift

Close

Knex Parallel Arm Lift

Here is my newest lift: the Parallel arm lift!
Most credits go to Shadowman, as he invented this lift first in his unfinished ball machine, I tried to rebuild it from the vid (only managed to rebuild the front part of the arm and some basic ideas).
So, this instruction is very complicated and nothing for absolutely beginners.
And it is also loooooooooong.
Be sure that all 3D connectors are turned correctly, with some you also have to pay attention that they aren't turned 180°, I'll note which in the image notes, so be sure to read them!
Sorry for any fails I made, making instructions was quite complicated.
And feel free to ask if you have any problems!
I use a plug-in motor, and I would recommend also using one as they have more power than the battery motors. Maybe you could use two battery motors...
Be sure to comment, rate and subscribe!
Oh, and the first one to make a piece count will earn a patch (But please be honest about it)
Be sure to check out my website!