• GWorks
    Global Moderator
    Sr. Member

Cyber K'NEX Bobcat / Skid Steer


Step 4: Rear End - Upper part

This step will show you how to make the upper part of the rear end.
The processor unit is put in it's place. You don't have mind the place of the cables too much, yet. Then the ON/OFF switch is added at the rear. This is used to turn the complete model ON. Then the battery pack for motor 1 is put in it's place, after which the motor and the worm gear are installed. Then the gears are put in place and you will make the Bobcat's roof & roll-cage.